Your joystick. Your buttons. 8 new outputs.
Wire up solenoids, lights, or valves. Name each button, pick an icon, assign to your joystick. No extra switches.
From $1,099·5-year warranty·Ships worldwide
Every added function is another wiring job.
To control a new output on a tractor you wire in a switch, route cables through the cab, and label it. Every change means doing it again.
Crowded dash and armrest
Each new function gets its own switch. After a few additions, finding the right one takes longer than using it.
Cables through the cab
Every switch needs wires routed from the dash to wherever the load is. Usually a half-day job per function.
Tractor controls go unused
The tractor has a Virtual Terminal and AUX-N joystick designed for exactly this. Standard relays don't connect to either.
Changes mean more wiring
Swapping a function, adding one, or moving it means opening panels again and running more cables.
One module. Eight outputs. Zero new switches.
Plug into ISOBUS. Your outputs show up on the screen. Assign them to any button, or control from the screen.
On the Virtual Terminal
On the joystick assignment page
Name a button once — the same label carries over to the joystick assignment page. No re-labeling when you swap implements.
It shows up on your screen
Whatever your brand, ISOBUS Block runs on the terminal you already have.
Brand names are the property of their respective owners. ISOBUS Block is not affiliated with or endorsed by any tractor manufacturer.
Pick your install path
Three ways to buy the same 8-channel relay platform. Start with the bare module, add a cabin harness, or skip the workshop and plug a weatherproof kit straight into the implement.
The Module
The building block. DIN-rail relay unit, ISOBUS connector, firmware.
- 8 × 10A relay outputs with NO, COM, NC per channel
- DIN-rail mount — you pick the enclosure
- You supply the harness and loom to your loads
- For integrators and workshops wiring from scratch
Cabin-Ready
Module plus a pre-built 1.8 m harness to the in-cab ISOBUS connector. Plug it in, done.
- Everything in The Module
- 1.8 m pre-built harness from module to the in-cab ISOBUS connector
- Same in-cab ISOBUS connector on every tractor brand
- You run the output side to your loads
Plug-and-Play
Weatherproof kit, pre-wired Deutsch connectors, mounts on the implement.
- Everything in Cabin-Ready, pre-wired
- IP-rated enclosure bolts to the implement frame
- 8 × Deutsch DT connectors on the output side
- One cable to the tractor — no workshop day needed
Not sure which fits? Ask on WhatsApp
Workshop, dealer, or ordering multiple units? Contact us for volume pricing
Industrial isolation
Optocoupler and power isolation.
5-Year Warranty
Five-year warranty. If it fails, we replace it.
Designed in Finland
Designed and tested in Finland. A professional tool for professional use.
Free Worldwide Shipping
Shipping included. Ships within 1 business day.
Works With Your Tractor
Any tractor with AUX-N controls. John Deere, Fendt, Valtra, Case IH, and more.
Questions?
Straight answers to the ones operators ask before they order.
I wondered why something like this didn't exist already, when it makes building your own setups so much easier. So I made one, and here it is. Message me if anything comes up.
Eetu Tervo · Founder
Questions before you order?
Reach a human on WhatsApp — typical reply in minutes, not days.
Chat with us on WhatsApp